 |
| |
 |
 |  |
| |
| RT5064 Radiation Kit |
Enables students to investigate the nature of heat radiation
and the radiating properties of different surfaces. The
kit comprises:
»
One radiant heater mounted on a base with mains lead
»
One metal plate approximately 150mm square with handle
»
One heat shield 220mm square with a 25mm diameter hole
in the center
»
One glass sheet 220mm square
»
One book of aluminium leaf
»
One pack of lampblack |
| |
| |
|
|
Photo Not Available |
|
| RT5066 Calorimeter, Student |
Consists of one spun inner vessel 75x50mm
diameter, carried on a 100x75mm diameter outer vessel.
Felt jacket is provided between the vessels and also at
the bottom of the outer vessel for proper insulation.
Fitted with a Bakelite cover with two holes. One hole
is for rubber stopper which will hold the thermometer
and the other hole is for the stirrer. Complete with rubber
stopper, stirrer and washer, but without thermometer.
| -01 |
Aluminium construction. |
| -02 |
Copper construction. |
|
| |
| |
|
|
|
|
| RT5067 Calorimeter, Electric
(Joule’s) |
| For determination of specific heat capacity of the liquid
by electrical method. Consists of an inner vessel 75x50mm
diameter, carried on a 100x75mm diameter outer vessel.
Fitted with a Bakelite cover with two 4mm sockets which
connects to a 6 ohm heating coil having maximum current
capacity of 1A. Complete with rubber stopper for holding
thermometer (not supplied) and a stirrer. |
| |
| -01 |
Aluminium construction. |
| -02 |
Copper construction |
|
|
|
|
|
| RT5071 Steam Generator |
| Copper body and conical top. Fitted with inlet and outlet
tubes and water gauge. |
| |
| |
|
|
|
|
| RT5074 Demonstration Steam
Engine Model, Locomotive Type |
| Actual working sectional model showing cross section
of the piston and slide valve, method of turning steam
on and off. All parts such as crankshaft, valve, control,
drive wheel etc. are clearly shown. |
| |
| |
|
|
|
| |
|
 |
|
 |
|
